Carbon Fiber Sheet or Lamp Film Frequently Asked Questions

Our carbon fiber wrapping sheets are sold in 24"x48" (2'x4') sheet sizes ONLY, we do not carry any sizes larger than this. Since we cannot determine the size of the application you wish to apply our vinyl wrap on, we highly recommend that you first measure the dimensions of your application prior to purchasing to determine how much you need to get.

Back to Top

Our glossy headlight/tail lights films are sold in 12"x48" (1'x4') sizes ONLY, we do not carry any sizes larger than this. However, this film will be definitely large enough to cover the entire lamp and for fog lamps, the size will be definitely large enough to cover both.

Note: the matte finishing headlight/tail lights films are sold in 24" x 24".

Back to Top

We will recommend dry applying since the vinyl film is self-adhesive already, therefore all you need to do is to make sure the surface is completely cleaned and dry and directly apply the vinyl film on.

Back to Top

You can use either a heat gun or a hair dryer to heat up the vinyl film a little bit and then apply it along the curve.

Back to Top

No, it should not. Our vinyl film is designed to be applied and taken off with relative ease. However, there may be residue left on some applications depending on the application material, how long it’s been on there, and if there was heat from the application; in those cases, it can be easily removed by using “Goo-Gone” which is a gentle adhesive remover.

Back to Top

You can visit our vinyl film DIY guide for detail information on how to apply the vinyl films, carbon fiber sheets and more.

Back to Top

Because iJDMTOY car sticker is made with KK reflective material. If you look at this reflective vinyl decal by itself, it does appear a little bit grayish. This coating is similar to the material found on most license plate which needs reflect the light.

Back to Top